Artículo set
Este producto contiene los siguientes elementos individuales:
| Nombre | Cantidad | |
|---|---|---|
|
Soporte de punta de dosel de vidrio Lieke
7744020101012
|
2 Piezas | |
|
Soporte de punta de dosel de vidrio Aminata
7744020201012
|
2 Piezas | |
|
Soporte de punta de dosel de vidrio Renata
7744020301012
|
2 Piezas | |
|
Varilla con rosca M10 izquierda/derecha Dyonne
7744028201012
|
2 Piezas | |
Información sobre el producto "Marquesina de vidrio con puntos de fijación Dittie"
A glass canopy with point brackets charmingly sets the scene for your entrance area.
The Dittie glass canopy with point brackets is supported by 6 point brackets made of stainless steel and stabilized by 2 additional rods, each of which connects 2 point brackets with each other. The glass canopy is firmly anchored at 4 points. The combination of point fixings and special glass enables an extremely high load of 2.51 kN/m².
The Aminata point fasteners for glass mounting are fixed in the glass by means of pre-drilling. Additional point holders are used for mounting on a load-bearing wall.
The angle of the glass canopy is slightly sloping at 93° so that water runs off to the front.
- easy installation
- for glass thickness: 10mm -17.52mm
- up to 2.51 kN/m2 load capacity
- individual dimensions possible
- stainless steel design
- maximum projection: 1300 mm
| Archivo | Category | Tamaño | Tipo de archivo | Prio |
|---|---|---|---|---|
| 77-29-2010-010-12_static-analysis_G-FITTINGS.pdf | Ficha técnica | 790.25 KB | ||
| 77-29-2010-010-12_regulations_G-FITTINGS.pdf | Ficha técnica | 346.06 KB | ||
| 77-29-2010-010-12_datasheet_G-FITTINGS.pdf | Ficha técnica | 421.39 KB |
Propiedades "Marquesina de vidrio con puntos de fijación Dittie"
| Autoportante: | no |
|---|---|
| Capacidad de carga: | 2,51 kN/m² |
| Cristal: | 10 - 17,52 mm |
| Longitud en mm: | 1800 |
| Material: | Acero inox 304 (V2A) |
| Montaje en: | Pared |
| Procesamiento de vidrio: | sí |
| Superficie: | Diseño acero inoxidable |
| Vidrio: | SentryGlas® 17,52 mm |
| max. capacidad de carga: | 1300 mm |
Sealing profile for glass Lara
The universal LARA sealing profile from G-Fittings with a width of 40 mm is used to connect and seal two panes of glass from 10.76 mm thick.
Connection and sealing of the butt joint of two panes of glass.
Total width 40mm
Length 2500 mm
For 10,76-21,52 mm glass
10 mm between the glass panes (7 mm bridge)
Color transparent
Material PVC
very good resistance to weathering, aging, UV and ozone
no special glue needed