Ce produit contient les articles individuels suivants :
Nom | Quantité | |
---|---|---|
Porte-canopée Lieke
7744020101012
|
2 Pièces | |
Porte-canopée Aminata
7744020201012
|
2 Pièces | |
Porte-canopée Renata
7744020301012
|
2 Pièces | |
Tige avec filetage M10 gauche/droite Dyonne
7744028201012
|
2 Pièces |
A glass canopy with point brackets charmingly sets the scene for your entrance area.
The Dittie glass canopy with point brackets is supported by 6 point brackets made of stainless steel and stabilized by 2 additional rods, each of which connects 2 point brackets with each other. The glass canopy is firmly anchored at 4 points. The combination of point fixings and special glass enables an extremely high load of 2.51 kN/m².
The Aminata point fasteners for glass mounting are fixed in the glass by means of pre-drilling. Additional point holders are used for mounting on a load-bearing wall.
The angle of the glass canopy is slightly sloping at 93° so that water runs off to the front.
- easy installation
- for glass thickness: 10mm -17.52mm
- up to 2.51 kN/m2 load capacity
- individual dimensions possible
- stainless steel design
- maximum projection: 1300 mm
Fichier | Catégorie | Taille | Type de fichier | Prio |
---|---|---|---|---|
77-29-2010-010-12_static-analysis_G-FITTINGS.pdf | Fiche technique | 790.25 KB | ||
77-29-2010-010-12_regulations_G-FITTINGS.pdf | Fiche technique | 346.06 KB | ||
77-29-2010-010-12_datasheet_G-FITTINGS.pdf | Fiche technique | 421.39 KB |
Autoportant: | non |
---|---|
Capacité de chargement: | 2,51 kN/m² |
Finition: | Design en Inox |
Fixation en: | Mur |
Longueur en mm: | 1800 |
Matériel: | Inox 304 (V2A) |
Traitement verre: | oui |
Verre: | SentryGlas® 17,52 mm |
max. capacité de chargement: | 1300 mm |
Épaisseur de verre: | 10 - 17,52 mm |