Glass canopy with point holders CTO Dittie

DITTIE - The glass canopy with point fixings for stylish entrance areas

The DITTIE glass canopy combines modern design with proven stability. Supported by solid stainless steel point brackets and additionally stabilized by two tie rods, the result is a load-bearing structure with clear lines - ideal for architecturally appealing entrance areas. It is attached using four points: Two high-quality point brackets support the canopy directly, while two additional stainless steel rods provide the necessary bracing and give the structure maximum security even under high wind and snow loads.

High load-bearing capacity & discreet appearance

The combination of point support technology and special glass allows an impressive load-bearing capacity of up to 2.51 kN/m² - which corresponds to around 250 kg/m². At the same time, the appearance remains deliberately understated: The stainless steel brackets stand back discreetly so that the glass canopy emphasizes the architecture of your building, not overpowers it.

The canopy is designed with a slight angle of inclination of 93° so that rainwater can run off to the front in a controlled manner and does not collect at the edge. It is attached using the tried-and-tested point fixings, which are pre-drilled directly into the glass and friction-fitted to the wall.

Simply configured & precisely delivered

With our configurator, you can plan your glass canopy online in just a few steps: simply enter the dimensions and select the design options - done. The matching brackets, rods and installation materials are supplied directly.

Technical features at a glance

• For glass thicknesses from 10 to 17.52 mm
• Load capacity: up to 2.51 kN/m²
• Max. Projection: 1300 mm
• Angle of inclination: 93°
• Material: Stainless steel AISI 304 (V2A)
• Easy installation thanks to sophisticated bracket system