Glass canopy with point holders CTO Dittie
Product number:
77990077
Description
A glass canopy with point fixings adds a charming touch to your entrance area.
The Dittie glass canopy with point brackets is supported by two stainless steel point brackets and stabilized by two additional rods. The glass canopy is thus firmly anchored to the wall via four points. The combination of the point fixings and special glass enables an enormously high load-bearing capacity of up to 2.51 kN/m².
The Aminata point fixings for glass installation are fixed into the glass by means of pre-drilling. Additional point fixings are used for mounting on a load-bearing wall.
The angle of the glass canopy is slightly sloped at 93° so that water drains to the front.
- Simple installation
- for glass thickness: 10 to 17.52 mm
- up to 2.51 kN/m2 load capacity
- Individual dimensions possible
- Stainless steel design
- Material: AISI 304 stainless steel (V2A)
- max. projection: 1300 mm
Key Features
for glass thickness: 10 to 17.52 mm
Up to 2.51 kN/m2 load capacity
Material: Stainless steel AISI 304 (V2A)
max. projection: 1300 mm
Simple assembly
Properties
| Finish: | Stainless steel design |
|---|---|
| Glass: | SentryGlas® 17.52 mm |
| Glass cut outs: | yes |
| Glasstärke: | 10 - 17,52 mm |
| Length in mm: | 1800 |
| Load capacity: | 2.51 kN/m² |
| Material: | Stainless steel 304 (V2A) |
| Mounting on: | Wall |
| Self-supporting: | no |
| max. projection: | 1300 mm |
Downloads
| 77-29-2010-010-12_static-analysis_G-FITTINGS.pdf | Datasheet | 790.25 KB | |||
|---|---|---|---|---|---|
| 77-29-2010-010-12_regulations_G-FITTINGS.pdf | Datasheet | 346.06 KB | |||
| 77-29-2010-010-12_datasheet_G-FITTINGS.pdf | Datasheet | 421.39 KB |