Mirror systems
Filter
–
Mountingspacer for mirror profile 5535 Alphie
100 pieces, wood black, 80 x 8 x 6 mm
To order this product, please log in here.
Mirror clips Bambi
Das Spiegelklammer-Set BAMBI von G-Fittings dient zur einfachen Anbringung von Spiegeln, Bildern und Schildern. Das Set besteht aus zwei feststehenden Klammern und zwei Klammern mit Federn und Korkeinlage. Nach der Befestigung am Spiegel drückt man die Federn mit der Spiegelkante nach unten und führt sie oben in die feststehenden Klammern ein. Das Set ist für eine Glasstärke von 4 - 6 mm und max. 12 kg geeignet.
Tipp: Achten Sie darauf, dass der Spiegel erst in die unteren Halter eingehängt wird und anschließend mithilfe des Federzuges der oberen Halter fixiert wird.
Lieferumfang
2 Oberteile mit Federmechanismus
2 Unterteile
4 Schrauben
4 Dübeln
To order this product, please log in here.
Mirror screws Myronne
Surface:
Stainless steel design, material zamak
|
Ø Diameter:
16 mm
100 pieces
To order this product, please log in here.
Mirror demisting pad Kjersti
Dimensions:
150 x 200 mm
The mirror heater KJERSTI is simply glued to the Rückside of the mirror. Fine heating wires in the film provide for the heating of the mirror in 3 - 5 min. to 28 °C. Connection is simple to the existing bathroom lighting or über separate switch (not included). Electrical connection should be carried out only by a professional. A transformer is not required. When switched on, the mirror is heated and remains clear. It is T & V and type tested, has the CE mark, and can be connected directly to 220 - 230V. The connection cable is about 1 meter long.
Installation:
The mirror heaters are designed for glass mirrors only. Make sure the mirror is larger in size compared to the drying panel of the mirror. Remove the self-adhesive layer on the Rüback of the mirror heater and mount it directly on the back of the mirror, not allowing the formation of air bubbles or wrinkles. Do not mount the mirror on or near the metal surfaces, such as aluminum, stainless steel, etc. If you fix the mirror on the wall using the adhesive, the adhesive must be applied along the edge of the mirror (minimum free space of 40 mm between the panel and the edge of the mirror). Do not apply adhesive on the drying panel. Do not cut or modify the mirror heater. Wiring shall be done based on IEE – regulations.
Note:
All electrical connections must be carried out by a trained electrician.
To order this product, please log in here.