with point holder
Filter
–
Glass canopy with point holders Dittie
A glass canopy with point brackets charmingly sets the scene for your entrance area.
The Dittie glass canopy with point brackets is supported by 6 point brackets made of stainless steel and stabilized by 2 additional rods, each of which connects 2 point brackets with each other. The glass canopy is firmly anchored at 4 points. The combination of point fixings and special glass enables an extremely high load of 2.51 kN/m².
The Aminata point fasteners for glass mounting are fixed in the glass by means of pre-drilling. Additional point holders are used for mounting on a load-bearing wall.
The angle of the glass canopy is slightly sloping at 93° so that water runs off to the front.
easy installation
for glass thickness: 10mm -17.52mm
up to 2.51 kN/m2 load capacity
individual dimensions possible
stainless steel design
maximum projection: 1300 mm
To order this product, please log in here.
Sealing profile for glass Lara
The universal LARA sealing profile from G-Fittings with a width of 40 mm is used to connect and seal two panes of glass from 10.76 mm thick.
Connection and sealing of the butt joint of two panes of glass.
Total width 40mm
Length 2500 mm
For 10,76-21,52 mm glass
10 mm between the glass panes (7 mm bridge)
Color transparent
Material PVC
very good resistance to weathering, aging, UV and ozone
no special glue needed
To order this product, please log in here.