Free shipping
Shipping within 24h
Competent advice
Purchase comfortable on invoice
+44 (0)1782 491 030

with point holder

Filter
Glass canopy with point holders Gilla

To order this product, please log in here.

Glass canopy with point holders Dittie
A glass canopy with point brackets charmingly sets the scene for your entrance area. The Dittie glass canopy with point brackets is supported by 6 point brackets made of stainless steel and stabilized by 2 additional rods, each of which connects 2 point brackets with each other. The glass canopy is firmly anchored at 4 points. The combination of point fixings and special glass enables an extremely high load of 2.51 kN/m². The Aminata point fasteners for glass mounting are fixed in the glass by means of pre-drilling. Additional point holders are used for mounting on a load-bearing wall. The angle of the glass canopy is slightly sloping at 93° so that water runs off to the front. easy installation for glass thickness: 10mm -17.52mm up to 2.51 kN/m2 load capacity individual dimensions possible stainless steel design maximum projection: 1300 mm  

To order this product, please log in here.

NEW
Sealing profile for glass Lara
The universal LARA sealing profile from G-Fittings with a width of 40 mm is used to connect and seal two panes of glass from 10.76 mm thick. Connection and sealing of the butt joint of two panes of glass. Total width 40mm For 10,76-21,52 mm glass 10 mm between the glass panes (7 mm bridge) Color transparent Material PVC very good resistance to weathering, aging, UV and ozone no special glue needed  

To order this product, please log in here.

Wall mounting plate Spijker

To order this product, please log in here.

Canopy point holder Renata

To order this product, please log in here.

Canopy point holder Aminata

To order this product, please log in here.

Canopy point fixing holder Lieke

To order this product, please log in here.

Rod with thread M10 left/right, L 830 mm Dyonne
Length: 830 mm

To order this product, please log in here.